TOYOTA VIP RS3000 Programming (AX005-99)
Publication date: 1999-04-09Reference number: AX005-99
TOYOTA VIP RS3000 PROGRAMMING
TECHNICAL SERVICE BULLETIN
| COPYRIGHT: | © 2018 Toyota, USA License Agreement TMS1002 |
TOYOTA VIP RS3000 PROGRAMMING
Model(s): Toyota, All Models
Section: Accessories
Bulletin No.: AX005-99
Date: April 9, 1999
INTRODUCTION
This bulletin describes the procedures that are used to program the two-button remote control for vehicles that are equipped with the dealer or port installed option (PIO), not the factory security system. For factory security system remote control programming, refer to the appropriate vehicle repair manual.
Verification of the dealer or PIO Toyota VIP can easily be performed by identifying the status monitor or remote transmitter.
- The remote transmitter has two buttons, Top and Bottom. See Fig 1.
- The status monitor has a Toyota label, LED, and microphone. See Fig 2.
Starting with 1998 MY, the remote controls for the RS3000 System were revised with new coding logics. The color of the remote control cases was changed from Black to Gray to help identify the new remote controls. The new (Gray) remote controls will not work with the RS3000 ECU's produced prior to 1998 MY. The old (Black) remote controls are still available for Service Parts.
AFFECTED VEHICLES
All models with dealer or PIO equipped Toyota VIP (RS3000).
WARRANTY INFORMATION
| OPCODE | Description | Time | OPN | T1 | T2 |
|---|---|---|---|---|---|
| N/A | Not Applicable to Warranty | ..... | ..... | ..... | ..... |
PROGRAMMING PROCEDURE
For location of the RS3000 ECU, refer to ECU Mounting Locations. See Fig 7.
I - TO PROGRAM (ADD) A REMOTE CONTROL TO THE SYSTEM
- Insert the key into ignition switch, and turn it to "ON."
- Press and hold ECU's PROGRAMMING SWITCH for 3 seconds. See Fig 3. The STATUS MONITOR LED turns on for 5 seconds. See Fig 4.NOTE: You must perform the next step within 5 seconds.
- Press and release the REMOTE CONTROL's top or bottom button. See Fig 1.NOTE: Either button on your REMOTE CONTROL can be programmed to operate the system. The bottom button can be programmed to operate a second vehicle with the Toyota VIP.
- The STATUS MONITOR LED turns off.
- The Piezo "chirper" chirps once.
- The exterior lights flash once.
- Turn off the ignition. The ECU will now operate with the REMOTE CONTROL just programmed.
II - TO ERASE ALL REMOTE CONTROL CODES FROM THE SYSTEM
- Insert key into the ignition switch, and turn it to "ON."
- Press and hold ECU's PROGRAMMING SWITCH for 3 seconds. See Fig 3. The STATUS MONITOR LED turns on for 5 seconds. See Fig 4.NOTE: You must perform the next step within 5 seconds.
- Press and hold the ECU's PROGRAMMING SWITCH for over 2 seconds again. See Fig 6.
- The STATUS MONITOR LED turns off, then flashes 3 times.
- The Piezo "chirper" chirps 3 times and the exterior lights flash 3 times.
- Turn off the ignition. The ECU has cleared all REMOTE CONTROL codes; until another REMOTE CONTROL is programmed, the system will not work with any REMOTE CONTROL.