Engine Stalls

Engine Starts And Then Stalls

• On Avalon, Camry 2.2L 4-cylinder gasoline models, Camry 3.0L V6, Camry Solara, Celica, Corolla, ECHO, Highlander, MR2, Prius, RAV4, Sienna, Tacoma, Tundra 3.4L V6 and 4Runner, check fuel pump control circuit. See FUEL PUMP CONTROL CIRCUIT under COMPUTERIZED ENGINE CONTROLS in appropriate SYSTEM & COMPONENT TESTING article.
• On Land Cruiser, check fuel pump control circuit. See DTC P1200: FUEL PUMP RELAY/ECU CIRCUIT test in SELF-DIAGNOSTICS - LAND CRUISER article.
• On MR2 with sequential manual transaxle, check throttle body and components for Electronic Throttle Control System (ETCS). See THROTTLE BODY under IDLE CONTROL SYSTEMS in SYSTEM & COMPONENT TESTING - 4-CYLINDER article. Models with sequential manual transaxle may be identified by the shift lever pattern which consists of "R", "N", "S" and "+" in place of the conventional type shift lever pattern and no clutch pedal is used.
• On Sequoia and Tundra 4.7L V8, check fuel pump control circuit. See DTC P1200: FUEL PUMP RELAY CIRCUIT test in appropriate SELF-DIAGNOSTICS article.

Engine Stall During A/C Operation

• Check A/C signal. A/C signal may also be referred to as A/C switch signal or compressor circuit. See appropriate MANUAL or AUTOMATIC A/C-HEATER SYSTEMS article in AIR CONDITIONING & HEATING.
• Check Engine Control Module (ECM) electrical connector for loose, damaged or corroded terminals and repair as necessary. For illustration of ECM location, see THEORY & OPERATION article. If electrical connector is okay, check ECM ground circuits. See WIRING DIAGRAMS article. Repair as necessary. If ground circuits are okay, replace ECM with a known-good ECM and retest.