Charging System - Generators & Regulators: Generator: Replacement

REPLACE FRONT BEARING
1. Remove the 4 screws and bearing retainer.
  
  Fig 1: Removing Bearing Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a press, press out the bearing.
  
  Fig 2: Using SST To Remove Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  SST 09950-60010 (09951-00260, 09952-06010)
3. Using SST and a press, press in a new bearing.
  
  Fig 3: Using SST To Install New Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  SST 09950-60010 (09951-00500)
4. Install the bearing retainer with the 4 screws.
  Torque: 3.0 N.m (31 kgf.cm, 27 in.lbf)
REPLACE REAR BEARING
1. Using SST, remove the bearing cover (outside) and bearing.
  
  Fig 4: Using SST To Remove Bearing Cover (Outside) & Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  SST 09820-00021
  
  NOTE: Be careful not to damage the fan.
2. Remove the bearing cover (inside).
3. Place the bearing cover (inside) on the rotor.
  
  Fig 5: Placing Bearing Cover (Inside) On The Rotor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using SST and a press, press in a new bearing.
  
  Fig 6: Using SST To Install New Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  SST 09820-00031
5. Using SST, push in the bearing cover (outside).
  
  Fig 7: Using SST To Push In Bearing Cover (Outside)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  SST 09285-76010