lemon-mirror:
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Bench Testing >> Solenoid Tests

Solenoid Tests

CAUTION: DO NOT engage starter solenoid for more than 5 seconds during testing, or damage to coil winding will result.
  1. Pull-In Coil Test -  Disconnect field coil lead from terminal "C". Connect a battery positive lead to terminal No. 50 and negative lead to terminal "C" and switch body. See Fig 1. Ensure that the clutch pinion gear moves outward. If not as specified, check and replace the magnetic switch. If as specified, go to step  2.
  2. Hold-In Coil Test -  Disconnect negative lead from terminal "C". See Fig 2. Ensure that the pinion gear remains in outward position. If not as specified, check and replace the magnetic switch. If as specified, go to step  3.
  3. Pinion Gear Return Test -  Disconnect the negative lead from the switch body. See Fig 3. Verify that clutch pinion gear returns inward. If not as specified, check and replace the magnetic switch. If as specified, switch is good.
Fig 1: Solenoid Pull-In & Hold-In Coil Test
G98H10220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Solenoid Hold-In Coil Test
G98C10225Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 3: Solenoid Drive Pinion Return Test
G98D10226Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror