lemon-mirror:
Home >> Toyota >> 2004 >> Sequoia Limited, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> SFI System >> Fuel Pump >> Removal

Fuel Pump: Removal

CAUTION: Do not smoke or work near an open frame when working the fuel pump.
  1. REMOVE FUEL TANK (See  FUEL TANK AND LINE   ) 
  2. DISCONNECT FUEL PUMP & SENDER GAUGE CONNECTOR 
  3. DISCONNECT VAPOR PRESSURE SENSOR CONNECTOR 
  4. DISCONNECT FUEL MAIN TUBE AND RETURN TUBE FROM FUEL PUMP AND SENDER GAUGE ASSEMBLY (See  PRECAUTION   )  
  5. REMOVE FUEL PUMP AND SENDER GAUGE ASSEMBLY FROM FUEL TANK 
    1. Remove the 8 bolts.
    2. Pull out the fuel pump and sender gauge assembly.
      NOTE:
      • Do not damage the fuel pump filter.
      • Be careful not to bend the arm of the sender gauge.
    3. Remove the gasket from the fuel section plate.
    Fig 1: Removing Bolts
    G04207823Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE LEAD WIRE FROM FUEL PUMP 
  7. REMOVE FUEL PUMP FROM FUEL PUMP BRACKET 
    1. Pull out the lower side of the fuel pump from the pump bracket.
    2. Disconnect the fuel hose from the fuel pump, and remove the fuel pump.
    3. Remove the rubber cushion from the fuel pump.
    Fig 2: Removing Fuel Pump From Fuel Pump Bracket
    G04207824Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE FUEL PUMP FILTER FROM FUEL PUMP 
    1. Using a small screwdriver, remove the clip.
    2. Pull out the pump filter.
    Fig 3: Removing Clip
    G04207825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror