lemon-mirror:
Home >> Toyota >> 2007 >> FJ Cruiser RWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Windshield/Window Glass >> Power Window Regulator Motor >> Installation

Power Window Regulator Motor: Installation

  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY 
    1. Apply MP grease to the sliding and rotating areas of the regulator motor.
    2. Using "Torx" socket wrench T25, install the power window regulator motor with the 3 screws.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      Fig 1: Identifying Power Window Regulator Motor Screws
      G05114314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY  (See REASSEMBLY )
  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY  (See REASSEMBLY )
  4. INSTALL FRONT DOOR WINDOW FRAME REAR LOWER  (See REASSEMBLY )
  5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH  (See REASSEMBLY )
  6. INSTALL FRONT DOOR FRAME SUB-ASSEMBLY FRONT LOWER  (See REASSEMBLY )
  7. INSTALL FRONT DOOR GLASS RUN  (See REASSEMBLY )
  8. INSTALL FRONT DOOR WEATHERSTRIP  (See REASSEMBLY )
  9. INSTALL FRONT DOOR CHECK ASSEMBLY  (See REASSEMBLY )
  10. INSTALL FRONT DOOR INSIDE PANEL PLATE  (See REASSEMBLY )
  11. INSTALL FRONT DOOR SERVICE HOLE COVER  (See REASSEMBLY )
  12. INSTALL FRONT NO. 1 SPEAKER  (See INSTALLATION )
  13. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY  (See INSTALLATION )
  14. INSTALL OUTER REAR VIEW MIRROR  (See INSTALLATION )
  15. INSTALL FRONT NO. 2 DOOR SERVICE HOLE COVER  (See REASSEMBLY )
  16. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
  17. INSTALL FRONT ARMREST BASE UPPER PANEL  (See REASSEMBLY )
  18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

· About lemon-mirror