lemon-mirror:
Home >> Toyota >> 2007 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2UZ-FE) >> Camshaft Position Sensor >> Removal

Camshaft Position Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. DRAIN ENGINE COOLANT (See  REPLACEMENT  ) 
  3. REMOVE V-BANK COVER SUB-ASSEMBLY (see  REMOVAL  ) 
  4. REMOVE INTAKE AIR CONNECTOR PIPE (see  REMOVAL  ) 
  5. DISCONNECT NO. 1 RADIATOR HOSE (See  REMOVAL  ) 
  6. REMOVE NO. 3 TIMING BELT COVER SUB-ASSEMBLY BANK 1 (See  REMOVAL  ) 
  7. REMOVE CAMSHAFT POSITION SENSOR 
    1. Remove the bolt, stud bolt and camshaft position sensor.
    Fig 1: Locating Bolt, Stud Bolt And Camshaft Position Sensor
    G05196914Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror