lemon-mirror:
Home >> Toyota >> 2007 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2UZ-FE) >> Circuit Opening Relay >> On-Vehicle Inspection

On-Vehicle Inspection

  1. REMOVE CIRCUIT OPENING RELAY (Marking: C/ OPN) 
    1. Remove the engine room relay block cover.
    2. Remove the relay from the engine room relay block.
  2. CHECK CIRCUIT OPENING RELAY 
    1. Measure the resistance of the relay.

    Standard resistance 

    TESTER CONNECTION SPECIFIED CONDITION CHART

    Tester Connection Specified Condition
    3 - 5 10 kΩ or higher
    3 - 5 Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.

  3. INSTALL CIRCUIT OPENING RELAY 
    Fig 1: Circuit Opening Relay Circuit Diagram
    G04975260Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror