lemon-mirror:
Home >> Toyota >> 2007 >> Tacoma X-Runner >> Repair and Diagnosis >> Engine Performance >> Engine Control System (1GR-FE) >> Crankshaft Position Sensor >> Installation

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7.4 in.*lbf) 

    3. Connect the crankshaft position sensor connector.
  2. INSTALL COOLER COMPRESSOR ASSEMBLY 
    1. Install the cooler compressor assembly with the 4 bolts.

      Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf) 

    2. Connect the cooler compressor assembly connector.
    3. Install the suction hose sub-assembly with the bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

  3. INSTALL GENERATOR ASSEMBLY  (See INSTALLATION )
  4. INSTALL FAN SHROUD  (See INSTALLATION )
  5. INSTALL V-BANK COVER  (See INSPECTION  )
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

· About lemon-mirror