lemon-mirror:
Home >> Toyota >> 2008 >> Highlander Hybrid >> Repair and Diagnosis >> Engine Performance >> Engine Control System (Hybrid) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

  1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  3. REMOVE HOOD TO COWL TOP SEAL  (See REMOVAL )
  4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See REMOVAL )
  6. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  8. REMOVE NO. 2 ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  11. REMOVE AIR CLEANER BRACKET  (See REMOVAL )
  12. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
    2. Remove the engine coolant temperature sensor and gasket.
    Fig 1: Locating Engine Coolant Temperature Sensor Connector
    G05625743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror