lemon-mirror:
Home >> Toyota >> 2008 >> Highlander Hybrid >> Repair and Diagnosis >> Engine Performance >> Engine Control System (Hybrid) >> SFI System >> DTC P060B Internal Control Module A/D Processing Performance >> Inspection Procedure

Inspection Procedure

  1. CHECK DTC 
    1. Clear the DTCs (See DTC CHECK / CLEAR ).
    2. Turn the power switch off.
    3. Disconnect the cable from the negative battery terminal and wait for 1 minute.
    4. Connect the cable to the negative battery terminal.
    5. Turn the power switch on (IG).
    6. Check for DTCs.

    Result 

    RESULT CHART

    Display (DTC Output) Proceed to
    No output A
    P060B B
    P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C, P033D C

    B: REPLACE HYBRID VEHICLE CONTROL ECU  (See REMOVAL )

    C: GO TO DTC  (P0327, P0328, P0332, P0333 and P033D) (See DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW INPUT (BANK 1 OR SINGLE SENSOR); DTC P0328 KNOCK SENSOR 1 CIRCUIT HIGH INPUT (BANK 1 OR SINGLE SENSOR); DTC P0332 KNOCK SENSOR 2 CIRCUIT LOW INPUT (BANK 2); DTC P0333 KNOCK SENSOR 2 CIRCUIT HIGH INPUT (BANK 2)  )

    A: CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS  )

· About lemon-mirror