Confirmation Driving Pattern

KEY-OFF MONITOR DRIVE PATTERN
1. Connect the Techstream to the DLC3.
2. Confirm the following conditions are satisfied:
  - The fuel level is less than 90%.
  - The altitude is less than 8000 ft. (2400 m).
  - The vehicle is stopped (the vehicle speed is less than 2 mph).
  - The engine coolant temperature is 4.4 to 35°C (40 to 95°F)
  - The intake air temperature is 4.4 to 35°C (40 to 95°F)
3. Perform the drive pattern:
  1. Allow the engine to idle for 5 minutes or more.
  2. Turn the power switch off and wait 6 hours.
4. Check the monitor status with the Techstream.
PURGE FLOW MONITOR DRIVE PATTERN (P0441)
1. Connect the Techstream to the DLC3.
2. Confirm that the following conditions are satisfied:
  - The engine coolant temperature is more than 4.4°C (40°F).
  - The intake air temperature is more than 4.4°C (40°F).
3. Perform the drive pattern:
  1. Remove and reinstall the fuel cap to release the fuel tank pressure.
  2. Warm the engine until the engine coolant temperature reaches 75°C (167°F) or more.
  3. Run the engine at 3000 rpm once.
  4. Allow the engine to idle and turn on the air conditioning (A/C) for 1 minute.
4. Check the monitor status with the Techstream.