lemon-mirror:
Home >> Toyota >> 2008 >> Highlander Hybrid >> Repair and Diagnosis >> Engine Performance >> Engine Control System (Hybrid) >> Throttle Body >> Installation

Throttle Body: Installation

  1. INSTALL THROTTLE BODY ASSEMBLY 
    1. Install a new throttle body gasket to the intake air surge tank.
      Fig 1: Identifying Throttle Body Gasket
      G05625719Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the throttle body assembly with the 4 bolts.

      Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

      Fig 2: Locating Throttle Body Assembly Bolts
      G05200231Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the fuel vapor feed hose (A).
    4. Connect the No. 3 water by-pass hose (B).
    5. Connect the No. 2 water by-pass hose (C).
    6. Connect the throttle motor connector (D).
    Fig 3: Locating Throttle Motor Connector And Water By-Pass Hoses
    G05200236Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  4. ADD ENGINE COOLANT (for Engine)  (See REPLACEMENT )
  5. INSPECT FOR COOLANT LEAK (for Engine)  (See ON-VEHICLE INSPECTION )
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  7. INSTALL NO. 2 ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  8. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  9. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY  (See INSTALLATION )
  10. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See INSTALLATION )
  11. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  12. INSTALL HOOD TO COWL TOP SEAL  (See INSTALLATION )
  13. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  14. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
· About lemon-mirror