Window Defogger Wire: Repair

REPAIR DEFOGGER WIRE
1. Clean the broken wire tips with grease, wax and silicone remover.
2. Place masking tape along both sides of the wire.
3. Thoroughly mix the repair agent.
  DuPont paste:
  
  No. 4817 or equivalent
  
  Fig 1: Placing Masking Tape Along Both Sides Of Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a fine tip brush, apply a small amount of the agent to the wire.
5. After a few minutes, remove the masking tape.
  NOTE: Do not allow electricity to flow in the defogger wire for at least 24 hours.
  
  Fig 2: Identifying Fine Tip Brush & Repair Point
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002