Combination Meter: Installation

INSTALL COMBINATION METER ASSEMBLY
1. Connect the connectors.
  
  Fig 1: Locating Combination Meter Assembly Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the combination meter with the 4 screws.
  
  Fig 2: Identifying Combination Meter Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Connect the connector.
  
  Fig 3: Locating Finish Panel And Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 9 claws to install the finish panel.
  
  Fig 4: Identifying Finish Panel Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Attach the 4 claws.
  
  Fig 5: Identifying Instrument Cluster Finish Panel Sub-Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
1. Attach the 2 claws to install the panel garnish.
  
  Fig 6: Identifying Panel Garnish Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL PAD SUBASSEMBLY LH
1. Connect the connectors and 2 clamps.
2. Attach the 8 claws to install the panel pad.
3. Install the screw.
4. Install the clip.
  
  Fig 7: Identifying Lower Instrument Panel Pad Subassembly LH Clip Screw And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
1. Attach the 7 claws to install the panel cushion.
  
  Fig 8: Identifying Panel Cushion Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
1. Attach the 3 claws to install the panel garnish.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (See CUSTOMIZE PARAMETERS ).

Fig 9: Identifying Panel Garnish Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002