Shift Lever: Installation

INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
1. Install the floor shift with the 4 bolts. Tighten the bolts in the order shown in the illustration (Fig 1).
  Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
2. Connect the 2 connectors.
  
  Fig 1: Identifying Floor Shift Bolts Tightening Sequence
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
1. Turn the control shaft lever RH of the park/neutral position switch counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
2. Move the shift lever to N.
  
  Fig 2: Turning Control Shaft Lever RH Of Park/Neutral Position Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Temporarily install the floor shift gear shifting rod with the nut.
4. Tighten the nut while lightly pushing the lever rearward.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (w/ o Cool Box) (See INSTALLATION )
INSTALL COOLING BOX ASSEMBLY (w/ Cool Box) (See INSTALLATION )
INSTALL CONSOLE REAR END PANEL SUBASSEMBLY (See INSTALLATION )
INSTALL NO. 1 COOLER COVER (w/ Cool Box) (See INSTALLATION )
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (See INSTALLATION )

Fig 3: Pushing Lever
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CONSOLE CUP HOLDER BOX SUBASSEMBLY (See INSTALLATION )
INSTALL REAR UPPER CONSOLE PANEL SUBASSEMBLY (See INSTALLATION )
INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL PAD SUBASSEMBLY RH (See INSTALLATION )
INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL PAD SUBASSEMBLY LH (See INSTALLATION )
INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION (See INSTALLATION )
CHARGE REFRIGERANT (w/ Cool Box) (See REPLACEMENT )
CHECK FOR REFRIGERANT GAS LEAK (w/ Cool Box) (See REPLACEMENT )
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )