lemon-mirror:
Home >> Toyota >> 2009 >> Matrix XRS, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control System (2AZ-FE) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE ENGINE UNDER COVER RH 
  3. REMOVE V-RIBBED BELT  (See ON-VEHICLE INSPECTION )
  4. REMOVE GENERATOR ASSEMBLY  (See REMOVAL )
  5. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Separate the crankshaft position sensor connector clamp and wire harness.
    3. Remove the bolt and crankshaft position sensor.
    Fig 1: Locating Crankshaft Position Sensor Connector Clamp
    G06007638Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror