lemon-mirror:
Home >> Volkswagen >> 1988 >> Fox Base >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - BOSCH Cis-E >> Testing >> Electrical Components >> After Start Enrichment

After Start Enrichment

  1. Connect test harness and multimeter to DPR and vehicle harness. See Figure . Connect multimeter to test harness. Disconnect wiring from coolant temperature sensor. Ground high tension lead (terminal No. 4) from ignition distributor.
  2. Crank starter for 3 seconds. Return key to "ON" position. DPR current reading should increase to more than 120 mA for 20-50 seconds, and return to 80-110 mA range.
  3. If not, check starter signal to terminal No. 24 of ECU connector. Check signal from relay board to starter motor (terminal No. 15a on starter). On Quantum and Quantum Syncro, check voltage between ECU terminals No. 2 and 21. See VOLTAGE CHECKS and RESISTANCE CHECKS CHARTS in this article for appropriate testing procedure. If all wiring is okay, replace ECU.
· About lemon-mirror