Service Precautions
WARNING:
All models are equipped with a Supplemental Restraint System (SRS) that includes an air bag located in steering wheel. Use caution when working around steering column. Ensure battery is disconnected before attempting any repair. DO NOT
apply electrical power to any component on steering column without disconnecting air bag module (air bag could deploy).
NOTE:
For information on air bag DIAGNOSIS & TESTING or DISPOSAL PROCEDURES, see appropriate AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIPMENT section:
- 1995 Models, see: AIR BAG RESTRAINT SYSTEM
- 1996 Models, see: AIR BAG RESTRAINT SYSTEM
Observe these precautions when working with air bag systems:
- Disable air bag system before servicing any air bag system or steering column component. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Because of critical operating requirements of system, DO NOT attempt to service any air bag system component.
- Air bag parts should not be left unattended. They should be installed in vehicle immediately after removing them from their packaging.
- Air bag components which have been dropped onto a hard surface should not be used.
- Chemical cleaners, oil and grease should not contact vinyl covering on air bag module.
- Always disable air bag system before performing electric welding on vehicle.
- Air bag system can only be tested using Diagnostic Tester (VAG 1551 ). Never use test light on air bag system.