Brake Fluid Level, Checking
- Brake fluid must never come into contact with fluids containing mineral oils (oil, gas, cleaning solutions). Oils containing minerals damage seals and rubber grommets on brake systems.
- Brake fluid is poisonous. Do not let brake fluid come in contact with the paint due to its corrosive effects.
- Brake fluid is hygroscopic, meaning that it absorbs moisture from the surrounding air.
- Always store brake fluid in tightly-sealed containers.
- Wash off any spilled brake fluid with plenty of water.
- Follow all disposal regulations.
When filling, make sure that no fluid is trapped in the engine compartment.
Fluid which has been trapped can cause damage in the engine compartment.
Toothed belts and ribbed belts that have come into contact with oils, brake fluid or coolant, must always be replaced.
Brake Fluid Level at Pre-Delivery Inspection
-- The fluid level must be at the MAX mark -1- during the pre-delivery inspection.
To prevent the brake fluid from overflowing out of the reservoir, the level must not be over the MAX mark -1-.
Brake Fluid Level at Inspection Service
Brake fluid level in the reservoir must always be evaluated depending on the brake pad wear.
During operation of the vehicle, the brakes are automatically readjusted depending on wear of the brake pads. Because of the adjustment, brake fluid level will be slightly lower as a result.
Recommended Brake Fluid Level "Before" Reaching Brake Pad Wear Limit
- At the "MIN mark" and slightly above it -2-
Then filling is not required.
Recommended Brake Fluid Level, New Brake Pads, or Far Away from Brake Pad Wear Limit
- Between the MIN and MAX marks
If the fluid level goes below the MIN mark -2-, check the brake system for leaks before adding more brake fluid. Refer to the "repair procedure".