Specifications Index
SPECIFICATIONS INDEX
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | AIR CONDITIONING | |||
| Torque | OVERVIEW - A/C COMPRESSOR POWER UNIT | |||
| A/C Compressorm Bolt | 25 Nm | |||
| Refrigerant Line Bolt | 22 Nm | |||
| Axle Nut/Hub Nut | ||||
| Front | 200 Nm + 90° | |||
| Rear | 200 Nm + 90° | |||
| Battery | BATTERY, STARTER, GENERATOR, CRUISE CONTROL | |||
| Brakes | ||||
| Bleeding Sequence | HYDRAULIC SYSTEM | |||
| Disc Brakes | FRONT BRAKES or REAR BRAKES | |||
| Torque | Refer to the appropriate information in FRONT BRAKES or REAR BRAKES | |||
| Charging | ||||
| Generator | OVERVIEW - GENERATOR | |||
| Torque (Generator Without Bushings) | OVERVIEW - GENERATOR, WITHOUT BUSHINGS | |||
| Generator Bolts | 23 Nm | |||
| Terminal 30/B+ Nut | 20 Nm | |||
| Torque (Generator With Bushings) | OVERVIEW - GENERATOR, WITH BUSHINGS | |||
| Generator Bolt | 23 Nm | |||
| Terminal 30/B+ Nut | 20 Nm | |||
| Threaded Pin & Nut | 3.2 Nm | |||
| Drive Belts | ||||
| Belt Routing | ||||
| 1.4L Gas | See the illustration under OVERVIEW - RIBBED BELT DRIVE | |||
| 2.0L Gas | See the illustration under OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE | |||
| Engine Cooling | ||||
| General Service Specifications | Refer to the appropriate FLUID CAPACITY TABLES information. | |||
| Radiator Cap Pressure | ||||
| 1.4L Gas | The pressure release valve must open at 1.6 to 1.8 bar (23.2 to 26.1 psi) | |||
| 2.0L Gas | The pressure release valve must open at 1.6 to 1.8 bar (23.2 to 26.1 psi) | |||
| Thermostat R & I | ||||
| 1.4L Gas | COOLANT THERMOSTAT, REMOVING AND INSTALLING | |||
| Water Pump R & I | ||||
| 1.4L Gas | COOLANT PUMP, REMOVING AND INSTALLING | |||
| 2.0L Gas | COOLANT PUMP, REMOVING AND INSTALLING | |||
| Engine Mechanical | ||||
| 1.4L Gas | ||||
| Compression | COMPRESSION, CHECKING | |||
| Oil Pressure | OIL PRESSURE, CHECKING | |||
| Idle | minimum 0.6 bar (8.7 psi) | |||
| 2, 000 RPM | minimum 1.5 bar (21.75 psi) | |||
| 3, 800 RPM | minimum 2.8 bar (40.61 psi) | |||
| Overhaul | ENGINE ASSEMBLY [CZDA, DGXA, DJXA, CWLA] / CYLINDER HEAD, VALVETRAIN [CZDA, DGXA, DJXA, CWLA] / CRANKSHAFT, CYLINDER BLOCK [CZDA, DGXA, DJXA, CWLA] | |||
| 2.0L Gas | ||||
| Compression | COMPRESSION, CHECKING | |||
| Oil Pressure | OIL PRESSURE, CHECKING | |||
| Idle | 0.85 to 1.6 bar (23.2 psi) | |||
| 2, 000 RPM | 1.2 to 1.6 bar (17.4 to 23.2 psi) | |||
| 3, 700 RPM | 1.2 to 1.6 bar (17.4 to 23.2 psi) | |||
| Overhaul | ENGINE ASSEMBLY [DKFA, CXDB] / CYLINDER HEAD, VALVETRAIN [DKFA, CXDB] / CRANKSHAFT, CYLINDER BLOCK [DKFA, CXDB] | |||
| Fluid Specifications | Refer to the appropriate FLUID CAPACITY TABLES information. | |||
| Engine Oil Drain Plug | 30Nm | |||
| Flywheel/Flex Plate Torque | 60 Nm +90° | |||
| Fuel System | ||||
| Pressure Specification/Fuel Pressure Test Procedure | ||||
| 1.4L Gas/2.0L Gas | Transfer Fuel Pump -G6-, CHECKING | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Spark Plug | ||||
| 1.4L Gas | 04E 905 602 D | |||
| 2.0L Gas | 06K 905 601 K | |||
| Starting | ||||
| Starter | STARTER | |||
| Torque | Refer to the appropriate information in OVERVIEW - STARTER | |||
| Wheel Alignment | ||||
| Adjustment Specifications | AXLE ALIGNMENT / WHEEL ALIGNMENT SPECIFICATIONS (2019) / WHEEL ALIGNMENT SPECIFICATIONS (2020) / WHEEL ALIGNMENT SPECIFICATIONS (2021) | |||
| Torque | N/A | |||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 120 Nm | |||