SEV MARCHAL Alternators: Overhaul: Disassembly
- Remove brush holder attaching screws and carefully remove brush holder. Scribe a mark on end frames for reassembly reference, then remove four through bolts. Separate end frames by inserting two screwdrivers into notches on sides of alternator.CAUTION: Do not insert screwdrivers deeper than 0.08" (2 mm) or damage may occur to stator windings.
- Remove nuts and washers for positive and negative diode holders from end frame. Carefully remove stator from end frame. Hold rotor in a vise using special wood blocks so no damage will occur to rotor. Remove nut, washer, pulley, fan, key and spacer.NOTE: Check which way spacer faces for reassembly reference.
- Remove three attaching screws for bearing cap, then push rotor shaft from end frame. Press bearing from end frame. Use a puller to remove bearing from slip ring end of rotor.