Installation Procedure

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Sunroof Control Module (2) - Install

CAUTION:

Refer to Fastener Caution .

Sunroof Control Module Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Connect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Install the headlining trim panel (1).
Courtesy of GENERAL MOTORS COMPANY

Quarter Upper Trim Panel (1) - Install

[ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Quarter Window Trim Finish Panel Bolt (2)Install and tighten [ 2x ] - Fastener Specifications
Quarter Window Trim Finish Panel Bolt Cap (1) - Install [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Center Pillar Upper Trim Panel (1) - Install [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Center Pillar Upper Garnish Molding Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications
Center Pillar Upper Trim Panel Bolt Cap (1) - Install [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Roof Rail Rear Assist Handle (2) - Install [ 2x ]
Roof Rail Rear Assist Handle Bolt (1) - Install and tighten [ 4x ] - Fastener Specifications
Enable the SIR System. SIR Disabling and Enabling
Perform the necessary initialization procedure. Sunroof/Sunshade Motor Initialization