Front Wheel Speed Sensor: Removal

NOTE: Before proceeding with this procedure, refer to CAUTION .

Raise the vehicle.
Disconnect the wheel speed sensor cable connector from the wiring harness on the inside of the frame rail above the front suspension crossmember. (Fig 1 ). The connector has a locking tab which that must be pulled back before the connector release tang can be depressed, releasing the connection.

Fig 1: Identifying Wheel Speed Sensor Wiring Harness Connector
Courtesy of DAIMLERCHRYSLER CORP.
If the sensor being removed is a left front, unclip the speed sensor cable from the brake tube on the inside of and under the frame rail. (Fig 2 ).

Fig 2: Identifying Left Sensor Cable Routing Along Brake Tube
Courtesy of DAIMLERCHRYSLER CORP.
Remove the speed sensor cable grommet from the retaining bracket attached to the brake hose on the outside of the frame rail.
Remove the bolt mounting the wheel speed sensor head to the steering knuckle. (Fig 3 ).

Fig 3: Removing Wheel Speed Sensor
Courtesy of DAIMLERCHRYSLER CORP.

CAUTION: When removing a wheel speed sensor from the knuckle, do not use pliers on the sensor head. This may damage the sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.
Carefully, remove the sensor head from the steering knuckle.
Remove the screw securing the wheel speed sensor to the rear of the strut. (Fig 4 ). Remove the wheel speed sensor.

Fig 4: Locating Wheel Speed Sensor At Strut
Courtesy of DAIMLERCHRYSLER CORP.