lemon-mirror:
Home >> Chrysler >> 2002 >> Neon LE, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock >> Rear Wheel Speed Sensor >> Removal

Rear Wheel Speed Sensor: Removal

NOTE: Before proceeding with this procedure, refer to CAUTION  .
  1. Raise the vehicle.
  2. Disconnect the wheel speed sensor cable connector from the vehicle wiring harness. (Fig 1 ). Remove the clip attaching wheel speed sensor cable connector to the vehicle's body.
    Fig 1: Disconnecting Wheel Speed Sensor Connector
    G01031857Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the wheel speed sensor cable routing bracket from under rear brake flex hose mounting bracket. Then remove the speed sensor cable from the routing clips on the rear brake flex hose and chassis brake tube.
  4. Remove the bolt attaching the wheel speed sensor cable routing bracket to rear strut.
    CAUTION: When removing a wheel speed sensor from the rear disc brake adapter, do not use pliers on the sensor head. This may damage the sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.
  5. Remove the bolt attaching the wheel speed sensor to the rear disc brake adapter, then carefully remove the sensor head from the rear disc brake adapter and vehicle. Fig 2 ).
    Fig 2: Removing Rear Wheel Speed Sensor
    G01031858Courtesy of DAIMLERCHRYSLER CORP.
· About lemon-mirror