Power Window Master Switch Test

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Remove the power window master switch (see POWER WINDOW MASTER SWITCH REPLACEMENT ).
Disconnect the 22P connector (A) from the power window master switch (B).

Fig 1: Identifying 22P Connector And Power Window Master Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each position according to the tables.
Front Passenger's Switch

Fig 2: Continuity Chart - Left Rear Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Left Rear Switch

Fig 3: Continuity Chart - Right Rear Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Right Rear Switch

Fig 4: Continuity Chart - Driver's Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Driver's Switch

The driver's switch is combined with the control unit so you cannot isolate the switch to test it.

Instead, run the power window master switch input test procedures (see POWER WINDOW MASTER SWITCH INPUT TEST ). If the tests are normal, the driver's switch must be faulty; replace the power window master switch.
If the continuity is not as specified, replace the switch (see POWER WINDOW MASTER SWITCH REPLACEMENT ).