lemon-mirror:
Home >> Jeep >> 1998 >> Grand Cherokee 5.9 Limited >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> System Testing >> Vehicle Communications >> Test 10A - No Response From Powertrain Control Module

Test 10A - No Response From Powertrain Control Module

  1. If engine does not run, see appropriate article in the ENGINE PERFORMANCE Section. If engine runs, turn ignition off. Disconnect Powertrain Control Module (PCM). PCM is located at right corner of firewall. Turn ignition on. Connect jumper wire between ground and terminal C30 (Violet/Brown wire) on PCM connector.
  2. Using scan tool, select BODY, BODY COMPUTER, then SYSTEM TEST. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open Violet/Brown wire. If scan tool displays BUS SHORT TO GROUND, go to next step.
  3. Move jumper wire to terminal C28 (White/Black wire) on PCM connector. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open White/Black wire. If scan tool displays BUS SHORT TO GROUND, replace PCM.
NOTE: For connector terminal identification, refer to CONNECTOR IDENTIFICATION  . For wiring diagrams, refer to WIRING DIAGRAMS  . After each repair, perform TEST VER-1A  .
CAUTION: Always turn ignition off prior to disconnecting any module connector.
· About lemon-mirror