lemon-mirror:
Home >> Jeep >> 2004 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Steering >> Power Steering System >> Drag Link >> Installation

Drag Link: Installation

  1. Install the drag link adjustment sleeve and tie rod end. Position clamp bolts. See Figure.
  2. Position the drag link at the steering linkage. Install the drag link to the steering knuckle nut. Do the same for the tie rod and pitman arm.
  3. Tighten the nut at the steering knuckle to 47 N.m (35 ft. lbs.). Tighten the pitman nut to 81 N.m (60 ft. lbs.) and tie rod ball stud nut to 47 N.m (35 ft. lbs.). Install new cotter pins and bend end 60°.
  4. Install the steering dampener onto the drag link and tighten the nut to 74 N.m (55 ft. lbs.). Install a new cotter pin and bend end 60°.
· About lemon-mirror