lemon-mirror:
Home >> Jeep >> 2005 >> Wrangler X, Automatic >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front >> Spring >> Installation

Suspension System: Front: Spring: Installation

  1. Install jounce bumper into mount.
  2. Install the spring isolator.
    NOTE: Rotation of the spring and prying down slightly on the axle will aid in installation.
  3. Position the coil spring on the axle pad. It may be necessary to rotate the spring while installing.
  4. Install the spring retainer clip and bolt. Tighten bolt to 21 N.m (16 ft. lbs.).
  5. Raise the axle into position until the spring seats in the upper mount.
  6. Install the shock at the axle. (Refer to SUSPENSION/FRONT/SHOCK - INSTALLATION) .
  7. Install the ABS wire mounting brackets at the axle (if equipped).
  8. Install the track bar to the axle bracket. (Refer to SUSPENSION/FRONT/TRACK BAR - INSTALLATION) .
  9. Install the lower suspension arms to the frame. Install mounting bolts and nuts finger tight. (Refer to SUSPENSION/FRONT/LOWER CONTROL ARM - INSTALLATION) .
  10. Install the drag link to the right side knuckle. (Refer to STEERING/LINKAGE/DRAG LINK - INSTALLATION) .
  11. Remove the hydraulic jack from under the axle.
  12. Install the wheel and tire assemblies, (Refer to TIRES/WHEELS/WHEELS - STANDARD PROCEDURE) .
  13. Remove the supports and lower the vehicle.
  14. Tighten the lower suspension arms nuts to 115 N.m (85 ft. lbs.) at normal ride height with the vehicle weight.
· About lemon-mirror