Steering Column

Position front wheels straight ahead.
Remove and isolate the negative ground cable from the battery.
Remove the airbag. Refer to REMOVAL .
NOTE: If equipped with cruise control, disconnect clock spring harness from the cruise switch harness on the steering wheel.

Fig 1: Steering Wheel Puller
Courtesy of CHRYSLER LLC

1 - PULLER C-3894-A

2 - STEERING WHEEL
Remove the steering wheel (2) with puller C-3894-A (1) or an appropriate puller. See Fig 1. See REMOVAL .

Fig 2: Knee Blocker
Courtesy of CHRYSLER LLC
Remove steering column opening cover. Refer to REMOVAL . . See Fig 2

Fig 3: Removing/Installing Shroud
Courtesy of CHRYSLER LLC

1 - Upper Shroud

2 - Lower Shroud
Remove screws from the lower column shroud (2) and remove both the upper and lower shrouds. See Fig 3.

Fig 4: Steering Column Bolts
Courtesy of CHRYSLER LLC
Turn ignition key to the on position.
If vehicle is equipped with automatic transmission, disconnect shifter interlock cable from the column.

Remove the steering coupler bolt and column mounting nuts (2) then lower column (1) off the mounting studs.

Fig 5: Identifying Wiring Harness Column, Multi-Function Switch, Ignition Switch & Steering Column

Courtesy of CHRYSLER LLC

1 - Column Wiring Harness

2 - Multi-function Switch

3 - Ignition Switch

4 - Steering Column

Slide the shifter interlock cable from the tie straps.

Fig 6: Identifying Tilt Lever, Ignition Switch, Clockspring, Steering Column & SKIM/SKREEM

Courtesy of CHRYSLER LLC

1 - Tilt Lever

2 - Ignition Switch

3 - Clockspring

4 - Steering Column

5 - SKIM/SKREEM

Remove column (4).
Transfer the necessary parts if needed.
Remove clock spring (3), switches, (SKREEM if equipped) (5) See Fig 6. Refer to REMOVAL .