lemon-mirror:
Home >> Jeep >> 2021 >> Cherokee High Altitude, Automatic T/Case Control >> Repair and Diagnosis >> Transmission >> Automatic Trans >> 2.0L Cooling System >> Engine >> Radiator, Engine Cooling >> Removal

Radiator, Engine Cooling: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Drain the cooling system. Refer to DRAINING  .
    GC0187141Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the lower radiator hose (1).
  4. Remove the cooling fan. Refer to REMOVAL  .
    GC0187135Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    The transmission oil cooler lines do not need to be disconnected.

  5. Remove the bolts (1) and position aside the transmission cooler (2).
  6. Disconnect the A/C pressure switch wire harness connector.
    GC0187061Courtesy of CHRYSLER GROUP, LLC
  7. Remove the bolt (1) securing the A/C line to the radiator.
    GC0187037Courtesy of CHRYSLER GROUP, LLC
  8. Remove the nut (1) securing the A/C discharge and liquid line junction block to the bracket (2).
    GC0186773Courtesy of CHRYSLER GROUP, LLC
  9. Remove the four bolts (1) securing the condenser to the radiator and position aside the condenser.
    GC0186371Courtesy of CHRYSLER GROUP, LLC
  10. Remove the two bolts (3) and the upper left side radiator mount cover (4).
  11. Remove the two bolts (2) and the upper right side radiator mount cover (1).
    GC0186542Courtesy of CHRYSLER GROUP, LLC
  12. Pull the radiator forward releasing the isolators (1) from the mount and remove the radiator (2).
· About lemon-mirror