Repair procedures: Inspection

[Non-Adjust type] 

1. Connect a scantool on the Data Link Connector (DLC).
2. Turn the ignition switch ON.
3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

   Specification:  Refer to SPECIFICATION .

[Adjust type] 

1. Connect a scan tool to the Diagnosis Link Connector (DLC).
2. Start engine and check output voltages of APS 1 and 2 at C.T and W.O.T.

   Specification 

   ACCELERATOR POSITION AND OUTPUT VOLTAGE SPECIFICATION
   
   

   Accelerator Position	Output Voltage (V)
   	APS1	APS2
   C.T	0.7 ~ 0.8V	0.29 ~ 0.46V
   W.O.T	3.85 ~ 4.35V	1.93 ~ 2.18V

3. Turn ignition switch OFF and disconnect the scantool from the DLC.
4. Disconnect APS connector and measure resistance between APS terminals 4 and 5 (APS 1).

   Specification:  Refer to SPECIFICATION .

5. Disconnect APS connector and measure resistance between APS terminals 1 and 6 (APS 2).

   Specification:  Refer to SPECIFICATION .