lemon-mirror:
Home >> Mazda >> 2016 >> 5 GS, Automatic Trans >> Repair and Diagnosis >> Electrical >> Horns >> Instrumentation/Driver Info >> Parking Sensor Control Module Inspection >> Notes

Parking Sensor Control Module Inspection: Notes

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    4. Center console box (See CENTER CONSOLE BOX REMOVAL/INSTALLATION .)
    5. Console panel (See CONSOLE PANEL REMOVAL/INSTALLATION .)
    6. Center console (See CENTER CONSOLE REMOVAL/INSTALLATION .)
    7. Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
    8. Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
    9. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
    10. Front console (See FRONT CONSOLE REMOVAL/INSTALLATION .)
    11. Side panel (See SIDE PANEL REMOVAL/INSTALLATION .)
    12. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
    13. Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
    14. Passenger-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION .)
  3. Remove the parking sensor control module with the connector connected. (See PARKING SENSOR CONTROL MODULE REMOVAL/INSTALLATION .)
  4. Connect the negative battery cable.
  5. Measure the voltage at each terminal is as indicated in the Terminal Voltage Tables.
    • If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item(s)".
      • If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the parking sensor control module.
· About lemon-mirror