Keyless Receiver Inspection: Notes

Disconnect the negative battery terminal. (Refer to NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the following parts:
1. Trunk covering (Refer to TRUNK COVERING REMOVAL/INSTALLATION .)
2. Trunk board (Refer to TRUNK BOARD REMOVAL/INSTALLATION .)
3. Trunk side pocket (RH) (Refer to TRUNK SIDE POCKET REMOVAL/INSTALLATION .)
4. Trunk end trim (Refer to TRUNK END TRIM REMOVAL/INSTALLATION .)
5. Rear scuff plate (RH) (Refer to REAR SCUFF PLATE REMOVAL/INSTALLATION .)
6. Third-row seat cushion (Refer to THIRD-ROW SEAT CUSHION REMOVAL/INSTALLATION .)
7. Third-row seat back component (Refer to THIRD-ROW SEAT BACK COMPONENT REMOVAL/INSTALLATION .)
8. Trunk side trim (RH) (Refer to TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
Remove the keyless receiver with the connector still connected. (Refer to KEYLESS RECEIVER REMOVAL/INSTALLATION .)
Connect the negative battery terminal. (Refer to NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
  - If the system does not operate normally even though the parts under Inspection Item(s) and related wiring harnesses do not have any malfunction, replace the keyless receiver.