Verify Fuse Block Replacement

Temporarily connect the negative battery cable to verify that the related wiring harness is not heated.
Switch the ignition ON (engine off).
Verify that the fuse is not blown and the related wiring harness is not heated.
Perform the initial settings for the following systems:
- Power window system (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE ).
- Clock and audio
- Tire pressure monitoring system (TPMS) (See TIRE PRESSURE MONITORING SYSTEM INITIALIZATION PROCEDURE ).
- Verify DTCs using the M-MDS.
  - If a DTC is displayed, repair the malfunctioning part according to the corresponding DTC inspection.
    - After completion of repairs, clear all DTCs stored in the module.
Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION ).
Start the engine and maintain the idle status.
Operate all the switches of the interior/exterior lights of the vehicle and verify that all the lights illuminate and flash.
Operate the radio, climate control, wiper and washer switch, and selector lever (AT) and verify that they operate correctly.
Shift the selector lever to the P position, race the engine at approx. 3, 000 RPM from engine idling, and verify that there is no malfunction. (AT)
Perform a road test and verify that low speed, acceleration, shift -up/shift-down conditions are normal. (AT)