Pinion Clearance Check
- Disconnect motor field coil at solenoid "M" terminal and insulate the field connector. See Figure. Connect a 12-volt positive lead to solenoid "S" terminal and other lead to ground. Touch a jumper lead from solenoid "M" terminal to starter frame to shift pinion into cranking position.
- Push pinion away from stop retainer as far as possible. See Fig 1. Using a feeler gauge, ensure .010-.140" (.25-3.6 mm) clearance exists between pinion and retainer.
NOTE:
Pinion clearance is not adjustable. If clearance is not within specification, disassemble and recheck starter motor.