Transmission Control Device: Installation

Install the detention spring to the transmission case.
Tightening torque:

6 N.m (0.6 kgf-m, 4.3 ft-lb)

Fig 1: Identifying Detent Spring
Courtesy of SUBARU OF AMERICA, INC.
Insert the select lever, and then tighten the bolt.
Tightening torque:

6 N.m (0.6 kgf-m, 4.3 ft-lb)

Fig 2: Identifying Range Select Lever And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Insert the manual plate and parking rod.

Fig 3: Identifying Manual Plate And Parking Rod
Courtesy of SUBARU OF AMERICA, INC.
Insert a new straight pin to manual plate.

Fig 4: Identifying Manual Plate Spring Pin
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan and the control valve assembly. < Ref. to INSTALLATION , Control Valve Body. >
Turn over the transmission case to its original position.
Install the pitching stopper bracket.
Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)
Install and adjust the inhibitor switch. < Ref. to INHIBITOR SWITCH . >
Insert the inhibitor switch and transmission connector to the stay.

Fig 5: Identifying Inhibitor Switch And Transmission Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
Insert the input shaft while rotating it lightly by hand, and then check the amount of protrusion.
Normal protrusion A:

50 - 55 mm (1.97 - 2.17 in)

Fig 6: Identifying Input Shaft
Courtesy of SUBARU OF AMERICA, INC.
Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >