How To Proceed With Troubleshooting

The hand-held tester can be used at step  3,  6,  9, and  12.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step. 

2. CUSTOMER PROBLEM ANALYSIS (SEE  CUSTOMER PROBLEM ANALYSIS CHECK   ) 

   NEXT: Go to next step. 

3. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA (SEE  FREEZE FRAME DATA OF ABS   &  DTC CHECK/CLEAR   ) 

   NEXT: Go to next step. 

4. PROBLEM SYMPTOM CONFIRMATION 
   • SYMPTOM DOES NOT OCCUR: Go to step 5 
   • SYMPTOM OCCURS: Go to step   6 
5. SYMPTOM SIMULATION (SEE  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 

   NEXT: Go to next step. 

6. DTC CHECK (SEE  DTC CHECK/CLEAR   ) 
   • THERE IS NO OUTPUT: Go to step 7 
   • THERE IS OUTPUT: Go to step   8 
7. PROBLEM SYMPTOMS TABLE (SEE  PROBLEM SYMPTOMS TABLE   ) 

   CHECK FOR FLUID LEAKAGE AND GO TO STEP   10 

8. DTC CHART (SEE  DIAGNOSTIC TROUBLE CODE CHART   ) 

   NEXT: Go to next step. 

9. CIRCUIT INSPECTION (SEE  DTC C0200/31 RIGHT FRONT SPEED SENSOR CIRCUIT, DTC C0205/32 LEFT FRONT SPEED SENSOR CIRCUIT, DTC C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR, DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR   TO  CIRCUIT DESCRIPTION   ) 

   HINT:

   When 2 or more DTCs are recorded, and the problem is not identified, perform circuit inspection of the other DTCs.

   NEXT: Go to next step. 

10. IDENTIFICATION OF PROBLEM 

    NEXT: Go to next step. 

11. REPAIR 

    NEXT: Go to next step. 

12. CONFIRMATION TEST 

    NEXT: END